Welch’s training came in the 1970s while working at American Durafilm in Holliston, Mass., where he developed a way to vacuum form 8 x 12 in. sheets of DuPont’s Teflon FEP into sheets of steep-sided bumps that were then die-cut into tiny insulating sleeves for pacemaker batteries. “That began a focus on vacuum forming of fluoropolymers,” he recalls. “DuPont would send me leads, and I would figure out how to make what they wanted. I became the person to talk to.”

Once he started his own company, he continued to develop that specialty, designing and building his own single-station vacuum forming machines with very rapid heating and high-temperature capability. The machines use two 6800-watt heater banks made of a special Nichrome resistance ribbon fabricated for Welch by Process Thermodynamics Inc. in Brandon, Minn. These units heat up in less than a minute to a surface temperature of over 1000 F. His three production machines are identical to one lab line used for prototyping, so when a part goes commercial, he simply moves the tools from the lab to the production area.

No-fail parts
In Welch’s markets, there’s no room for product failure. His custom products include corrosion barriers for air regulators in gas masks and a liner of DuPont’s Kapton polyimide for a smoke hood used by commercial flight crews. The Federal Aviation Administration requires the hoods to withstand 1000 F for 5 seconds and to keep a person alive for 20 minutes in an oxygen-depleted environment.

Pro-active inventions
Sometimes Welch develops a process before he has a customer, figuring that once he can make it, someone will want it. For example, in 1988 he successfully vacuum formed Honeywell’s Aclar CTFE, a highly crystalline material with a Tg of 360 F. He heated a sheet of Aclar to 440 F to make it amorphous and easily formable, then cooled it to room temperature so fast, it didn’t have time to regrow crystals. He thus obtained clear, thin, flexible CTFE parts. He now vacuum forms over 20,000 lb/yr of CTFE for parts like moisture-protection covers for electrical circuitry. He designed and built two special automatic thermoforming machines just for the moisture covers.

Welch recently developed a unique process to form a sheet of 5-mil Teflon film over substructures like a foam donut or a silicone gasket. It took him six months of work. The process is being considered for gaskets for sanitary piping. Welch charges customers the full cost of his R&D time. “We’re not afraid to charge the customer for that which is unique,” he explains. “But mostly, I want people to look at one of my parts and say, ‘How the hell did he do that?’”